Bigtreetech Manta M8P 3d printer controller board

Manta M8P

Installed with 32-bit 64MHz ARM Cortex-M0 + STM32G0B1VET6 chip, more stable and faster.

Designed with the same connector as Raspberry Pi, giving you a confident connection with all versions of CM4, definitely, CB1. Also a screw-reinforced installation is also available.

It has rich expansion ports and can support various expansion modules, such as BL Touch, LCD screen, RGB light, auto shutdown, etc.

TPS5450-5A Power Chip The 5A output perfectly matches the power supply need of Raspberry Pi.

Selectable CNC fan voltage, 5V/12V/24V.

Added eFuse circuit protection. It will be faster disconnected on overload and automatically reset if the overload is gone, which will greatly reduce the motherboard burnout caused by short circuits or ignition.

Reserved Can Bus port can be connected with EBB CAN, simplifying the wiring and providing strong anti-interference ability.